When remodeling or updating a room, we all install a new door as the final touch. However, many people make common mistakes during the installation process. So, to avoid these mistakes, you should be prepared properly before starting a project.
Knowing what to do before the installation is very important if you’re working on an interior or exterior project. Incorrectly installing a door can cause issues which can be expensive to fix after the damage.
This blog will discuss the top five mistakes people often make when installing doors.
Things You Should Avoid During Door Installation
Let’s discuss the top 5 mistakes to avoid during door installation at the start.
Measuring Incorrectly
Many people try to guess when measuring doors, which leads to bad fitting. Always use a tape measure to measure the proper length, width, and thickness. Don’t forget to check the door frame and record the dimensions.
Remove the old frame when replacing an original door and measure the entire opening. Please make sure the new door and its framework match the measurements. The correct measurement is important and will save you from redoing the work.
Using the Wrong Screws
People often make the mistake of using the wrong screws when installing a door. However, this causes issues like the hinges not holding properly or the door scraping against the frame. Avoid this by choosing the correct size and type of screws that match the weight and material of the door.
When screwing in the hinges, don’t apply too much force. Tighten the screws enough to hold the hinges securely but not so much that it adds extra pressure on the door. Over-tightening can warp the door and eventually cause problems.
Over-Trimming
People often over-trim the door when installing a new one because they don’t measure accurately. Always double-check your measurements before cutting. Even trimming a few millimeters can cause the door to fit poorly. Take your time and measure carefully to avoid cutting too much.
If you cut too much, the door won’t fit properly, and you might need a replacement. Make sure you trim with caution and care to ensure a proper fit.
Hanging Upside Down
Another mistake people often make is hanging a door upside down because doors often look the same on both sides. It happens when you don’t pay close attention to the placement. But getting the side up wrong can cause problems with knobs and panels.
To avoid this, always double-check the placement before you install the door. Ensure the right side is up and everything is in the correct position. This practice will save you from a silly mistake and ensure the door works as it should.
Using the Wrong Tools
Using the wrong tools can cause problems when installing a door yourself. You need the right tools to get the job done correctly, such as a screwdriver, drill, hammer, and tape measure. For perfect work, don’t forget clamps, shims, and a utility knife.
When installing the door, make sure to have a saw, planer, and the proper tools for hinges and knobs. Using the wrong tools can cause mistakes and make the door installation more difficult.
Also Read: How to Fix Common Door Issues?
Reason to Hire a Professional
Many people make the mistake of installing a door without fully understanding the process and the complications that might happen because of the incorrect practice. Installing a door might seem easy, but it can quickly become tricky if you’re unprepared. Specific skills are required to avoid problems; without them, you might spend more time and labor than expected.
When installing a door, it’s better to hire a professional who knows the job well. They can ensure the door installation is done correctly the first time, avoiding problems in the future. In the long run, hiring a professional saves you time and reduces stress. They bring the right tools and expertise to make the job smoother and ensure your door is installed perfectly.
Conclusion:
If you face a problem with door installation, trying to fix it yourself might not always be the best way. Installing a door the wrong way can lead to more issues. Sometimes, the easy solution is to call a professional like Rochester Door Company. They can handle the problem and ensure everything is done correctly. So, instead of rushing, take the time to do it right and avoid future problems.
